enxrjm Posted March 6, 2004 Share Posted March 6, 2004 I'm going to fit some braided brake hoses and change the pads at the same time. I saw a link for a handbrake piston wind back tool but have now lost it. (They sell one on eliseparts but would rather save the tenner for something else ) Has anyone here either got one or have the dimensions for one so I can make it myself? Cheers. Link to comment Share on other sites More sharing options...
Scrappydog Posted March 6, 2004 Share Posted March 6, 2004 If your lucky you might not have to use the tool.A pair of needle nose pliers might do the trick. discussed in this SELOC thread: http://forums.seloc.org/viewthread.php?tid=17759 Andy Link to comment Share on other sites More sharing options...
enxrjm Posted March 6, 2004 Author Share Posted March 6, 2004 Was hoping to avoid needle nose pliers because of the risks of damaging the seal! The part I'm after is like a t-bar with 2 nobbles on the end - If I had dimensions I could get one made. Link to comment Share on other sites More sharing options...
Simon G Posted March 10, 2004 Share Posted March 10, 2004 I've got one if you want to borrow it? Link to comment Share on other sites More sharing options...
Mark A Posted March 10, 2004 Share Posted March 10, 2004 I've changed loads of pads with needle nosed pliers without a problem. Very difficult to damage the seal. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.